Publicité
Les langues disponibles
Les langues disponibles
6 - MARKING AND IDENTIFICATION
Model
Features
Year of construction
Serial Number
7 - MOUNTING OF THE HOSE (Models without hose)
7.1
7.2
BP
7.2
AP
7.3
We affix the CE and UKCA marking as the
manufacturer of this equipment.
On the equipment is securely attached a
tag with curing adhesive system on which
are indicated in addition to the name of the
manufacturer and the symbols "CE" and
"UKCA", all information necessary for good
identification of the machine (model, duty,
year of construction, weight, etc.).
Weight
QR-Code for manual
The hose reels without hose are supplied with the unloaded
spring.
Use a hose with dimension and pressure characteristics suitable
for use according to the hose reel model.
Normally, the hoses must be connected Female Straight Gas, ex-
cept for those to be used for the following fluids which must have
these characteristics:
-Diesel fuel: antistatic hose (R<1 mΩ/m). Hose without fitting.
-Urea / Cold water: Hose without fitting.
-Oil (3/4"): EN857 1SC hose with fitting F.90° 3/4"G.
-Oil (1"): EN857 1SC hose with fitting F.S.1"G.
-Water 400bar (1/2"): EN857 2SC hose with fitting F.90° 1/2"G.
7.0) Fix the hose reel to the bench and remove plastic protection.
7.1) For models with hose with fittings F.D. - F.90: Put the hose
between the guide rollers, connect it to the fitting which is
inside the drum and tighten by the suitable wrench.
7.2) Models Low Pressure 3/4"-1"(BP): Fix the hose clamp and
adjust it so that during rotation the hose reel is free to turn.
Models High Pressure 1"(AP): connect the hose (A) to the
curve, tightening with the suitable wrench. Tighten the nut
(B) on the connection of the drum.
7.3) Mount the lateral protection and rotate manually the drum in
order to rewind completely the hose.
7.4) Spring Preload: hold the hose-end and rotate the drum in
the opposite direction for a few laps(see technical manual).
During preloading do not release the hose. A violent in-
version of the rotation could cause damage to operators
and to the spring of the hose reel making the product
unusable.
7.5) Insert the hose-end between the guide rollers and put the
hose rubber stopper at the desired length.
7.6) Unwind the hose and rewind it completely, to check if the
hose reel works properly.
7.4
PRE-
LOAD
- 11 -
7.5
WARNING!
DO NOT PUT
HANDS OR ANY
OTHER THING
INSIDE THE DRUM!
Publicité
