Tennant LPTB03379 Manuel D'instructions page 21

5.1. Lifting and transporting the packaged machine
During all lifting operations, make sure the packaged machine is firmly secured to
Always load/unload lorries in adequately illuminated areas.
The machine is packaged on a wooden pallet by the Manufacturer. It must be loaded on
to the transporting vehicle using suitable equipment (see EC Directive 89/392 and
subsequent amendments and/or additions). At destination, it must be unloaded using
similar means.
The squeegees are packed in cardboard boxes without pallet.
A fork lift truck must always be used to lift the packaged body of the machine. Handle with
care to avoid knocking or overturning the machine.
5.2. Delivery checks
When the carrier delivers the machine, make sure the packaging and machine are both
whole and undamaged. If the machine is damaged, make sure the carrier is aware of the
damage and before accepting the goods, reserve the right (in writing) to request
compensation for the damage.
5.3. Unpacking
When unpacking the machine, the operator must be provided with the necessary
personal protection devices (gloves, goggles, etc.) to limit the risk of injury.
Proceed as follows to unpack the machine.
• cut and remove the plastic straps using scissors or nippers;
• remove the cardboard;
• remove the bags in the battery compartment (in the detergent tank) and check the
contents:
- guarantee slip;
- use and maintenance manual;
- battery bridges with terminals (battery model only);
- battery charger connector (battery models only);
• depending on the model, remove the metal brackets or cut the plastic straps fixing the
machine chassis to the pallet;
• using a sloping ramp, push the machine backwards off the pallet;
• unpack the brushes and squeegees;
• clean the outside of the machine in respect of safety regulations;
• after unpacking the machine, install the batteries (battery models) or connect the
electrical connections (cable models). See relevant sections.
The packaging may be kept and reused to protect the machine if it is moved to another
site or to a repair workshop.
Otherwise it must be disposed of in compliance with current legislation.
5.4. Electrical connections and earth (cable models)
The electrical characteristics of the machine are given on the rating plate (fig. 1). Make
sure the frequency and voltage correspond to those of the mains supply where the
machine will be operated. Make sure the frequency and voltage correspond to those of
the mains supply where the machine will be operated. As far as voltage is concerned,
models where the rating plate specifies a voltage of 230 V can be used with voltages of
ENGLISH
8
5.
MOVEMENT INSTALLATION
IMPORTANT
avoid it tipping up or being accidentally dropped.
IMPORTANT