Hillyard SENTRY 261R Manuel D'utilisation Et D'entretien page 25

PERFORM ALL MAINTENANCE OPERATIONS IN SEQUENCE
38. CLEANING THE RECOVERY TANK
1. Disconnect the tube (1) from its seat, unscrew the drainage cap and empty the recovery tank.
ATTENTION: Before performing any maintenance, remove the keys from the panel
and disconnect the battery connector of the machine.
ATTENTION: This operation must be carried out wearing gloves to protect against
contact with dangerous solutions.
2. Raise the cap (2) until the hook (4) is secured to the prop (3) of the recovery tank.
3. Clean and rinse the recovery tank and the suction pipe (connecting pipe between the squeegee and the
tank).
4. Reposition the cap on the drainage tube and lower the suction cap. To lock the prop (3) just slightly
raise the cap, release the prop (3) and lower the cap up to close it.
39. CLEANING THE SUCTION MOTOR FILTER
1. Raise the suction cover (2) and block it with the stop (3)
2. Remove the suction filter protection (5) by rotating it clockwise
3. Release the retaining clips (6)
4. Remove the suction filter (7) from its seat
5. Use a jet of water to clean the walls and base of the filter
6. Reassemble all the elements
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions.
ATTENTION: Before performing any maintenance, remove the keys from the
panel and disconnect the battery connector of the machine.
DAILY MAINTENANCE
ENG - pag. 25
2
4
3
6
7
5