Hillyard SENTRY 261R Manuel D'utilisation Et D'entretien page 13

9. MACHINE SIDE COMPONENTS
The side components of the machine are identified as follows:
14) Water-detergent filler cap
15) Water filler cap
16) Water-detergent drainage cap
10. REAR COMPONENTS OF THE MACHINE
The rear components of the machine are identified as follows:
17) Recovery tank discharge cap
11. BATTERY TYPE
To power the machine it is necessary to use:
• liquid-electrolyte lead traction batteries;
• sealed traction batteries with gas recombination or gel technology.
OTHER TYPES MUST NOT BE USED.
The batteries must meet the requirements laid out in the norms: CEI EN 60254-1:2005-12 (CEI 21-5) +
CEI EN 60254-2:2008-06 (CEI 21-7)
The battery compartment can house four 6V or two 12V batteries
For a good operating performance, we suggest the use of four 6V/210 Ah C5 batteries
12. BATTERY MAINTENANCE AND DISPOSAL
For maintenance and recharging, respect the instructions provided by the battery manufacturer.
Particular attention must be paid when choosing the battery charger, if not supplied, since there are
different kinds according to the type and capacity of the battery.
When the battery reaches the end of its working life, it must be disconnected by expert, trained personnel,
then lifted (using the grips and suitable lifting devices) to remove it from the battery compartment.
EXHAUSTED BATTERIES ARE CLASSIFIED AS DANGEROUS WASTE AND MUST BE CONSIGNED
TO THE AUTHORISED BODIES FOR CORRECT DISPOSAL.
PREPARATION OF MACHINE
ENG - pag. 13
15
14
16
17