Checking the battery pack charging
level
(Fig. B)
Check battery pack charge level: Press the
o
button
. The charging level LEDs
[
]
LED
[
]
Red/orange/green
Red/orange
Red
Charging the battery pack
(Fig. C)
NOTE
The battery pack
may be charged at any time
u
[
]
without reducing the life.
Interrupting the charging process does not damage the
u
battery pack
.
[
]
Charge the battery pack
o
medium or low charging level.
The charging control LEDs (green
o
the status of the charger
LED
Red LED lights up
Green LED lights up
Green and red LED flashing
Red LED flashing
Green LED lights up (without
battery pack)
Insert the battery pack
[
o
Connect the power cord with power plug
o
charger
to the socket.
[
]
When the battery pack
[
o
battery pack from the charger
power plug
of the charger from the socket.
[
]
Attaching/removing the accessory
tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and may become hot
during use. Always wear protective gloves when
handling accessory tools!
32 GB/IE
light up:
[
]
Charging level
Maximum
Medium
Low
before operation when it is at
[
]
and red
) indicate
[
]
[
]
and the battery pack
:
[
]
[
]
Status
Battery pack charges
Battery pack fully
charged
Battery pack defective
Battery pack too cold
or too warm
Charger ready
into the charger
.
]
[
]
of the
[
]
is fully charged: Remove the
]
. Then disconnect the
[
]
m
WARNING!
Always switch the product off, remove the battery
pack
and let the product cool down before
[
]
making any adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory tool when
u
the product is in operation.
m
CAUTION! RISK OF INJURY!
After the product has been switched off, the accessory
u
tool continues moving for some time. Do not touch the
accessory tool and do not attempt to brake it.
This product is equipped with an automatic spindle lock to open
or close the chuck
with the chuck ring
[
1 ]
Open the chuck
: Turn the chuck ring
1 ]
[
o
clockwise direction (Fig. E).
Insert a suitable accessory tool into the chuck
o
as required.
Close the chuck
: Hold the accessory tool in position.
[
1 ]
o
Turn the chuck ring
in a clockwise direction.
[
2 ]
NOTES
This product is equipped with a Röhm drill chuck with an
u
anti-lock function.
If you attempt to open the fully opened chuck
u
the anti-lock function will be activated to protect the
chuck.
When the anti-lock function is activated, the chuck
u
cannot be closed by turning the chuck ring
clockwise direction. A ratcheting sound will be produced
when you attempt to close the chuck.
Deactivating the chuck's
u
the chuck ring
in a clockwise direction by a certain
2 ]
[
extent. Then, turn the chuck ring
quickly in a counter-clockwise direction.
Repeat this action if the anti-lock function is still active.
When the anti-lock function is deactivated, you should
be able to close the chuck
Trial run
NOTE
Always carry out a no-load trial run before starting work
u
and after every accessory tool replacement. Switch
the product off immediately if the accessory tool is not
running smoothly, if considerable vibration occurs or if
you hear abnormal noises.
.
2 ]
[
in a counter-
[
2 ]
as deep
[
1 ]
further,
[
1 ]
1 ]
[
in a
2 ]
[
anti-lock function: Turn
[
1 ]
suddenly and
[
2 ]
without ratcheting sounds.
[
1 ]