Publicité
Les langues disponibles
Les langues disponibles
6. Assembly
•
Check that all parts, necessary tools and safety aids are present (e.g. helmet, gloves, safety shoes).
•
Assemble the components following the steps shown in appendix T4
•
Make all the connections as shown in Annex T3
•
See the table below for the reference to the annex with the configuration table and configurations per type of rolling tower
Configuration
EN
RS 44-POWER
RS 45-POWER
RS TOWER 54
RS TOWER 55
1. Mount the wheels (part T2.C) and secure with locking pin
2. Open the folding frame (part T2.A), place the platform (part T2.F) on the 2nd rung and secure it
3. Point the wheels outwards, put the brakes on
4. Place the horizontal brace (part T2.G) on the upper rung opposite the folding frame
5. Mount the stabilizers (part T2.J) at an angle of 45 degrees.
Scaffolding may only be assembled and used in accordance with local laws and regulations. Local legislation and regulations may contain
supplementary measures on top of this guide.
Control card
After assembly, the scaffold should be provided with a control card (clearly visible from the ground) on which the following information is
entered:
•
Contact details responsible person
•
Whether the scaffolding is ready for use
•
Load class and the equalized load
•
Whether the scaffolding is intended for indoor or outdoor use
•
Date of assembly
7. Check before use
1. Check that the rolling tower is horizontal (check using a spirit level)
2. Check that all wheels are on the brake.
3. Check that the stabilizers are properly adjusted and make good contact with the ground.
4. Check that the rolling tower is assembled in accordance with this manual and in conformity with the configuration and ballast table.
5. Check that the environmental factors, such as swinging doors ,awnings that operate automatically, aboveground electrical cables,
traffic and/or passers-by, etc., do not lead to dangerous situations.
6. Check that the rolling tower can be used safely and that it is suitable for the intended purpose.
8. Moving the rolling tower
The rolling tower may only be moved while observing the following conditions:
1. Do not move a rolling tower in winds exceeding 12.7 m/s (max. 6 Beaufort).
2. When the rolling tower is moved, persons and/or materials may not remain on the rolling tower.
3. Beforehand, checks should be made that the environmental factors, such as swinging doors, canopies, pits, automatically functioning
awnings, aboveground electrical cables, traffic and/or passers-by, etc. do not lead to dangerous situations while the scaffold is
moved.
4. In order to move the scaffold, the stabilisers can only be raised to a maximum of 3 cm.
5. Before moving the rolling tower, all wheels must be removed from the brake.
6. Only move the scaffold manually in a lengthways direction, over a flat, horizontal and sufficiently load-bearing surface.
7. After moving the rolling tower, check all the points listed in Section 7 "Before Using".
14
www.altrex.com
Attachment
T3
T3
T3
T3
Publicité
