Makita UB100D Manuel D'instructions page 11

NOTICE:
If the machine has been operated con-
tinuously until the battery has become empty, rest
the machine for at least 15 minutes before operat-
ing the machine with a fresh battery.
Speed adjusting dial
► Fig.10: 1. Speed adjusting dial
The speed can be changed by turning the speed adjust-
ing dial to a given number setting from 1 to 3. Higher
speed is obtained when the dial is turned in the direc-
tion of number 3. Lower speed is obtained when it is
turned in the direction of number 1.
Refer to the table for the relationship between the num-
ber settings on the dial and the speed.
Number
3
2
1
NOTICE:
When turning the dial, be sure to com-
pletely release the switch trigger. Otherwise, the
machine may be damaged.
OPERATION
CAUTION:
Do not place the machine on the
ground while it is switched on. Sand or dust may
enter from suction inlet and cause a malfunction or
personal injury.
Blower operation
CAUTION:
When performing the blower
operation, be sure to remove the dust bag from
the machine, and attach the nozzle in place for
blowing.
Hold the machine firmly with a hand and perform the
blowing operation by moving it around slowly. When
blowing around building, big stone or vehicle, direct the
nozzle away from them. When performing an operation
in a corner, start from the corner and then move to wide
area.
For UB100D
► Fig.11
For UB101D
► Fig.12
Vacuuming operation
operation, be sure to attach the dust bag and
nozzle in place to the machine.
wear or deterioration.
the dust bag before operating the machine.
before opening or fastening the fastener of the
dust bag.
NOTICE:
ation, do not use the garden nozzle. The materials
Speed
sucked may be clogged, and cause a malfunction of
High
the machine.
Medium
NOTICE:
Low wet leaves, and foreign materials, such as large
wood chips, metals, glass, pebbles, etc., to be
sucked into the machine. Otherwise, a malfunction
may occur.
NOTICE:
full. Otherwise, a malfunction may occur.
Hold the machine with both hands. While operating the
machine, adjust the switch trigger so that the suction
force is appropriate for the work location and conditions.
► Fig.13
Empty the dust bag before it becomes too full by remov-
ing the dust bag from the machine, and then removing
the fastener.
► Fig.14: 1. Fastener
MAINTENANCE
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Cleaning the machine
Clean the machine by wiping off dust with a dry cloth or
one dipped in soapy water and wrung out.
NOTICE:
alcohol or the like. Discoloration, deformation or
cracks may result.
Remove dust or dirt from the suction inlets.
► Fig.15: 1. Suction inlet
11 ENGLISH
CAUTION:
When performing the vacuuming
CAUTION:
Check the dust bag frequently for
CAUTION:
Be sure to fasten the fastener of
CAUTION:
Always switch off the machine
When performing the vacuuming oper-
Do not allow wet materials, such as
Empty the dust bag before it becomes
CAUTION:
Always be sure that the machine is
Never use gasoline, benzine, thinner,