Pioneer BDR-WX01DMU Manuel De L'utilisateur page 20

Connection
Connecting the USB cable
When using this product, connect the device to a computer using the included USB
cable.
This device supports hot plugging.
1 Turn on the computer power and start operating system.
2 With your Windows or Mac operating system running, connect the USB
connector on the rear of the device to the computer using the included USB
cable or USB conversion adapter.
• If connected to a USB 2.0 port, it will function as a USB 2.0 device.
• When using DM Archiver, connect to a USB 3.0 port.
During data transfer, do not remove the USB cable.
USB Type-A
(USB 3.0 or higher is
recommended)
Note
• It is recommended to connect to USB 3.0 port or above. If a USB 3.0 cable is
connected to a USB 2.0 port, the connection will be limited to USB 2.0 performance
standards.
• This unit can operate with USB 1.1 but will not provide optimum performance.
• Connecting this unit through a USB hub or using cables other than those specified
may result in faulty operation.
• The unit will not run on power supplied from the USB connector (bus power). Be
sure to use the unit with the AC adapter supplied with the unit connected.
• Do not use a USB cable or USB conversion adapter other than that included with
this device.
WARNING
Do not place the unit within the reach of young children as the USB conversion adapter
could be swallowed accidentally. In the event that a part is swallowed, seek medical
attention immediately.
20
BDR-WX01DMU En
USB Type-B
USB cable (accessory)