Operating Controls - VOLTCRAFT HPS-11530 Mode D'emploi

• If you have reason to believe that the device can no longer be operated safely, disconnect it immediate-
ly and make sure it is not unintentionally operated. It must be assumed that safe operation is no longer
possible if:
- the device shows visible damage,
- the device no longer works and
- the device was stored under unfavourable conditions for a long period of time or
- after it was exposed to extraordinary stress caused by transport.
• You should also heed the additional safety instructions in each chapter of these operating instructions
as well as in the operating instructions of the connected devices.

6. OPERATING CONTROLS

(1) Power switch for putting the device into operation (I=ON / 0=OFF)
(2) Voltage display "V"
(3) Current display "A"
(4) Status display output "C.V." (constant voltage operation)
(5) Status display output "C.C." (current limiter/constant current operation)
(6) Status display "REAR CONTROL" shows active remote control or fixed voltage operation
(7) Voltage control (with button function for coarse / fine adjustment)
(8) Current limiter control (with button function for coarse / fine adjustment)
(9) Minus pole connection socket (max. 5 A!)
(10) Plus pole connection socket (max. 5A!)
(11) Plus pole high-load connection (screw clamp with socket function)
(12) Minus pole high-load connection (screw clamp with socket function)
(13) Slider for selecting the 4 operating modes "MODE"
(14) "SENSE" remote sensor connection (HPS-11560 only)
(15) Slider for selecting the freely definable fixed voltage places "RECALL"
(16) Remove control connection "Remote Control"
(17) Temperature-controlled internal fan Do not cover!
(18) Grounded low-power connection for mains cable
(19) Fuse holder for the mains fuse
(See fold-out page)
33