Amica PEP4 Serie Mode D'emploi page 27

INSTALLATION INSTRUCTIONS
Connecting to electrical mains
Important!
Electrical connection must be made by a properly certified and qualified installer.
Do not make any alterations or changes in the appliance electrical system.
Tips for the installer
The hob is designed for three-phase AC power supply (400 V 3 N ~ 50 Hz). The hob can be
adapted to single phase power supply (230 V) by linking the appropriate terminal strip accord-
ing to wiring diagram. Wiring diagram is placed on the hob's underside. The terminal block
can be accessed by removing the lid on hob's underside. Remember to match the power
cord to the type of connection and the hob's power rating.
The connection cable must be secured in a cord relief bracket.
Important!
Remember to connect the neutral lead to correct terminal block clamp, marked
with .The electrical system supplying the hob must be protected by a properly
selected tripping device or a circuit breaker allowing to disconnect the power supply
in an emergency.
Before connecting to the appliance, please carefully read the information provided
on the rating plate and wiring diagram.
Important!
The installer is obliged to provide the user with „appliance electrical connection certificate"
(enclosed with the warranty card).
Connecting the hob other than shown on the wiring diagram may damage the hob.
27