Pioneer PDP-61MXE1 Mode D'emploi page 36

*1 Only when using a graphic accelerator board that is capable of displaying 852 480. *1 Only when using a graphic accelerator board that is capable of displaying 852 480.
*2 This signal is converted to a 1024 dots *2 This signal is converted to a 1024 dots
*3 The picture is displayed in the original resolution. *3 The picture is displayed in the original resolution.
*4 The aspect ratio is 5:4. This signal is converted to a 960 dots 768 lines signal. *4 The aspect ratio is 5:4. This signal is converted to a 960 dots 768 lines signal.
*5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the *5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the
RGB mode prepared for the input signals listed in the table above. RGB mode prepared for the input signals listed in the table above.
*6 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer's video port. *6 To connect the monitor to Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer's video port.
*7 Other screen sizes (ZOOM and WIDE) are available as well. *7 Other screen sizes (ZOOM and WIDE) are available as well.
*8 When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may sometimes be unstable (jumpy). *8 When viewing a moving picture at a vertical frequency greater than 65Hz, the picture may sometimes be unstable (jumpy).
If this occurs, please set the refresh rate of the external equipment to 60Hz. If this occurs, please set the refresh rate of the external equipment to 60Hz.
To view 480I@60Hz (480 interlaced lines, 60Hz refresh rate) or 576I@50Hz (567 interlaced lines, 50Hz refresh rate) when To view 480I@60Hz (480 interlaced lines, 60Hz refresh rate) or 576I@50Hz (567 interlaced lines, 50Hz refresh rate) when
sync polarity is "Sync on Green", set "RGB SELECT" to "MOTION". sync polarity is "Sync on Green", set "RGB SELECT" to "MOTION".
*9 CVT standard compliant. *9 CVT standard compliant.
NOTE: NOTE:
• While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the • While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the
picture or the fine picture because of errors in synchronization of your computer. picture or the fine picture because of errors in synchronization of your computer.
• When a 1280 dots • When a 1280 dots 1024 lines signal or 1600 dots 1024 lines signal or 1600 dots
• This monitor has a resolution of 1365 dots • This monitor has a resolution of 1365 dots
equivalent. equivalent.
• With digital input some signals are not accepted. • With digital input some signals are not accepted.
• The sync may be disturbed when a nonstandard signal other than the aforementioned is input. • The sync may be disturbed when a nonstandard signal other than the aforementioned is input.
• If you are connecting a composite sync signal, use the HD terminal. • If you are connecting a composite sync signal, use the HD terminal.
What is HDCP/HDCP technology? What is HDCP/HDCP technology?
HDCP is an acronym for High-bandwidth Digital Content Protection. High bandwidth Digital Content Protection (HDCP) is a system HDCP is an acronym for High-bandwidth Digital Content Protection. High bandwidth Digital Content Protection (HDCP) is a system
for preventing illegal copying of video data sent over a Digital Visual Interface (DVI). for preventing illegal copying of video data sent over a Digital Visual Interface (DVI).
If you are unable to view material via the DVI input, this does not necessarily mean the PDP is not functioning properly. With the If you are unable to view material via the DVI input, this does not necessarily mean the PDP is not functioning properly. With the
implementation of HDCP, there may be cases in which certain content is protected with HDCP and might not be displayed due to the implementation of HDCP, there may be cases in which certain content is protected with HDCP and might not be displayed due to the
decision/intention of the HDCP community (Digital Content Protection, LLC). decision/intention of the HDCP community (Digital Content Protection, LLC).
• "IBM PC/AT" and "XGA" are registered trademarks of International Business Machines, Inc. of the United States. • "IBM PC/AT" and "XGA" are registered trademarks of International Business Machines, Inc. of the United States.
• "Apple Macintosh" is a registered trademark of Apple Computer, Inc. of the United States. • "Apple Macintosh" is a registered trademark of Apple Computer, Inc. of the United States.
640 lines signal. 640 lines signal.
1200 lines signal is input to the monitor, the picture will be compressed. 1200 lines signal is input to the monitor, the picture will be compressed.
768 lines. It is recommended that the input signal should be XGA, wide XGA, or 768 lines. It is recommended that the input signal should be XGA, wide XGA, or
31
En