Publicité
Les langues disponibles
Les langues disponibles
SCREEN SIZE Operation with
Computer Signals
Switch to the wide screen mode to expand the 4 : 3 image
to fill the entire screen.
1. Press the SCREEN SIZE button on the remote control.
2. Within 3 seconds ...
Press the SCREEN SIZE button again.
The screen size switches as follows:
→ 4:3 → FULL → ZOOM
4:3 size screen (4:3 or SXGA 5:4)
The picture has the same size as the normal computer image.
FULL size screen
The image is expanded in the horizontal direction.
ZOOM size screen
When wide signals are input.
FULL size screen
When "PICTURE SIZE" is set to "OFF"
* This cannot be set in some models. "DOT BY DOT" will
not be displayed in such cases.
The screen size switches as follows:
→ D BY D → FULL → ZOOM
DOT BY DOT screen (VGA, SVGA 4:3)
The image is dot by dot resolution.
10
En
FULL size screen
The image is expanded in the horizontal and vertical
direction.
ZOOM size screen
When wide signals are input.
FULL
DOT BY DOT
The image is dot by dot resolution.
* "D BY D" can be switched only when a 1280 dot
line signal is input.
Information
Supported resolution
See page 30 for details on the display output of the
various VESA signal standards supported by the
monitor.
"PICTURE SIZE" setting
When the setting of "PICTURE SIZE" is OFF, the size
of RGB-input pictures will be D BY D in place of 4:3.
When 852 (848) dot
signals with a vertical frequency of 60 Hz and
horizontal frequency of 31.7 (31.0) kHz are in-
put
Select an appropriate setting for RGB SELECT mode
referring to the"Table of Signals Supported" on page
30.
* "VGA", "SVGA" and "SXGA" are registered
trademarks of IBM, Inc. of the United States.
Note:
Do not allow the displayed in 4:3 mode for an extended
period. This can cause a phosphor burn-in.
768
480 line wide VGA*
Publicité
