LIVARNO home GT-13589 Notice De Montage page 8

Congratulations!
You have chosen to purchase a high-quality
product. Familiarise yourself with the product
before using it for the first time.
Read the following assembly
instructions and the safety
information carefully.
Use the product only as described and only
for the given areas of application. Store these
assembly instructions carefully. When passing
the product on to third parties, please also hand
over all accompanying documents.
Package contents (Fig. A)
1 x table top, reversible (1)
2 x table frame, long side (2)
1 x table frame, short side (3)
1 x table frame, adjustable height, short side (4)
2 x struts (5)
16 x screw (6)
16 x washer (7)
16 x cover cap (8)
1 x hex key (9)
1 x assembly instructions
Intended use
The product is designed for outdoor use, e.g.
on a balcony or terrace or in the garden. The
product is not intended for commercial use.
Technical data
Dimensions: approx. 140 x 74 x 92cm
(L x H x D)
Weight: approx. 20kg
Maximum load: 50kg
Date of manufacture (month/year):
10/2023
8 GB/IE
Safety information
Life-threatening hazard!
• Never leave children unattended with the
packaging materials. There is a risk of suffo-
cation.
Risk of injury!
• Ensure the product is properly stabilised
before using it.
• Place the product on a level surface.
• The product may only be used under adult
supervision and must not be used as a toy.
• Check the product for damage or wear
before each use. Only use the product if it is in
perfect condition!
• Never stand or sit on the product.
Preventing damage to the
product!
• Secure the product during extreme weather
conditions, e.g. strong wind. Store the product
in a sheltered area.
Assembly (Figs. B–D)
1. First place the tabletop (1) on a flat, clean
and soft surface. Warning! Hard surfaces can
scratch the product.
2. Connect the long sides of the table frame (2)
to the short sides (3)/(4) as shown in Fig. B.
3. Place the two struts (5) in the table frame and
connect them (Fig. C).
Note: do not fully tighten the screws (6) before
placing the table top (1) on the frame.
4. Turn the product over and place it flat on the
ground.
5. Carefully place the table top on the table
frame (Fig. D).
Note: to compensate for unevenness of the
floor, you can turn the rotary wheel on the table
frame (4) in or out.