Publicité
Les langues disponibles
Les langues disponibles
Ensure that all seals are correctly seated to pre-
vent leakage of water.
The spout can be swiveled to your desired
position. Make sure the spout is always posi-
tioned within the area of the sink, otherwise
escape of water can lead to serious flooding
to your house or building.
C AUTION! DANGER OF SCALDING!
When making the hot water setting please
ensure that the temperature of the water is not
too high.
Before installation, make yourself familiar with
all the existing services, e.g. water connection
and stopcocks.
Please read carefully through these operating
instructions before installing and using the
product. Keep all the safety advice and instruc-
tions in a safe place for future reference!
Installation
I
s n
a t
l l
n i
g
h t
e
Turn off the main water supply to prevent serious
leakage of water. Allow any remaining water
in the pipework to drain.
Install the tap as shown in Fig. A‒E.
C
A
U
I T
O
N
!
Do not bend the hoses or place
them under tension. Otherwise material dam-
age could result.
F
u l
h s
n i
g
h t
e
a t
The tap must be flushed through before first use
to remove any dirt. To do this, follow these
steps (see Fig. F):
Screw the gasket
18
aerator cover
off.
20
Open the main water supply and allow the
water to run for two minutes.
Then screw the gasket
and aerator cover
20
6 GB/IE/NI/CY/MT
a t
p
p
, aerator insert
and
19
, aerator insert
18
19
on again.
Water-saving function
The cartridge
in this tap has an Eco-Click
12
function. This feature limits the water flow through
the tap (see Fig. H).
Lift the lever
until you notice a slight resist-
17
ance. This resistance will cause a stop in case
of partial opening and will therefore simply limit
the flow of water.
If you want to increase the flow rate, exert slight
pressure on the lever
resistance.
Energy saving function by cold
Start
To reduce energy consumption, our valve
offers the cold start. This prevents, when using
the single-lever mixer, the middle lever position
for warm water. Since the middle position is
the most frequently used, energy consumption
can be significantly reduced in this way. The
"neutral" center position of the handle can only
be used for cold water, which means that only
hot water is needed when you really need it,
Which means you can save a lot of money
-especially when using the cold start function.
Operation
r B
n i
g
n i
g
n i
o t
Note: If the tap has not been used for a long pe-
riod flush the pipes through thoroughly in order to
avoid stagnation and build-up of residues in the
drinking water supply.
Open the main water supply.
Lift the control lever
or left in order to regulate the speed or temper-
ature of the water flow.
until you overcome the
17
u
e s
and swing it to the right
17
Publicité
