Mounting - ETNA AG160WIT Mode D'emploi

INSTALLATION
EN 12
Mounting of the hood between two hanging cupboards
1. Drill 2 holes (A) of 2,5 mm diameter on the side of the hanging
cupboards as showed in the Fig. considering also the thickness of
the front panel, so that the hood remains at the same level of the
side hanging cupboards.
2. Fix the hood to the hanging cupboards through 4 screws, which are
appropriate to that kind of cupboard.
3. Close the space, which eventually remains between the hood
and the wall adjusting the spacer (L) by acting on the appropriate
screws (P).
L
P
Mounting of the hood on the wall
1. Drill 4 holes on the wall as shown in the figure.
2. Fix the spacer (L) on the wall at the right height, according to
the depth of the hanging cupboards.
3. Adjust the position of the superior clamps (M), according
to the depth of the hanging cupboards.
4. Fix the hood on the wall through 4 screws and dowels with
expanding plug, which are appropriate to that kind of wall (ex.
concrete, plasterboard, etc.).
5. Fix the hood to the spacer through the screws (P).
G
H
E
M