Application (App); Memory Function; Error Codes; Important Notices - LaserLiner DistanceMaster Compact Plus Mode D'emploi

Application (app)

An app is required to use the Bluetooth
the app from the corresponding stores for the specific type of terminal
device:
!
Make sure that the Bluetooth
is activated.
After starting the app and activating the Bluetooth
can be set up between a mobile device and the laser distance meter.
If the app detects several active measuring devices, select the matching
device.
This measuring device can be connected automatically the next time
it is switched on.
* The Bluetooth word mark and the logo are registered trademarks of Bluetooth SIG Inc.
®

Memory function:

or

Error codes:

Err101: Replace the battery
Err104: Calculation error
Err152: Temperature is too high: > 40°C
Err153: Temperature is too low: < 0°C
Err154: Outside the measuring range
Err155: Received signal too weak
Err156: Received signal too strong
Err157: Incorrect measurement or background is too bright
Err160: The device is moving too much to measure.

Important notices

– The laser points to the location that will be measured.
No objects may get into the laser's line of measurement.
– The device compensates the measurement for different room
temperatures. Therefore allow the device a brief adaptation period
when changing locations with large temperature differences.
– The device is only conditionally useable in outdoor areas and cannot
be used in strong sunlight.
– The measurement results of outdoor measurements may be influenced
or falsified by rain, fog and snow.
– In unfavourable conditions, e.g. with poorly reflecting surfaces, the
maximum deviation may be greater than 3 mm.
– Carpeting, upholstery or curtains will not reflect the laser optimally.
Measure to flat surfaces.
14
EN
®*
3 sec
View stored values
function. You can download
®*
interface of the mobile device
function, a connection
®*