Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Unpack Range
WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Remove shipping materials, tape and protective film from
range. Remove oven racks and parts package from inside
oven.
2. Do not remove the shipping base at this time.
A
A. Shipping base
3. On Ranges Equipped with Storage Drawers:
Remove the storage drawer. Use a ³⁄₈" drive ratchet to lower
the rear leveling legs one-half turn. Use channel lock pliers to
lower front leveling legs one-half turn.
On Ranges Equipped with Warming Drawers:
Use channel lock pliers to lower the front and rear leveling legs
one-half turn.
B
³⁄₈
A.
" drive ratchet
B. Rear leveling leg
C. Channel lock pliers
D. Front leveling leg
INSTALLATION INSTRUCTIONS
A
D
C
Install Anti-Tip Bracket
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death
or serious burns to children and adults.
Contact a qualified floor covering installer for the best procedure
for drilling mounting holes through your type of floor covering.
Before moving range, slide range onto shipping base, cardboard
or hardboard.
1. Remove template from the anti-tip bracket kit (found inside
the oven cavity) or from the back of this manual.
2. Place template on the floor in cabinet opening so that the left
edge is against cabinet and top edge is against rear wall,
molding or cabinet.
3. Tape template into place.
4. If countertop is not flush with cabinet opening edge, align
template with overhang.
If cabinet opening is wider than that specified in the "Location
Requirements" section, adjust template so range will be
centered in cabinet opening.
5
Publicité
Table des Matières
