Sono Swiss preSET SW 1/H Mode D'emploi page 37

7. First Start-up
Install drain nozzle
(drain SET SW6H to SW30H standard; SW3H optional)
PRE
Scope of delivery: Hose nozzle, sealing plug, hose clamp
1. Screw in hose nozzle clockwise
2. Turn the hose nozzle in the desired drain direction.
The plastic thread is self-sealing as soon as it can no longer be turned by hand.
3. You can now establish a connection to a drain on the building side. Use a
commercially available hose (1/2" diameter) for this. Slide the hose onto the hose nozzle and
fasten it with the hose clamp included in the scope of delivery.
Option: Stainless steel drain
Complete piping in stainless steel is also possible as an option.
1. The stainless steel drain valve is positioned on the rear side of the machine.
2. Due to the different positioning of the valve - in comparison with the standard version -
side operation is no longer possible. The red lever on the rear side of the machine must be
operated to open the valve.
3. The installation of the hose nozzle, the sealing plug and the hose clamp
is not different from that for the standard version.
SONOSWISS_GebrauchsanleitungD-E-FR-IT-ES_ARIAL_P.indd 37
EN | 37
16.10.18 08:02