Thermador Emerald DWHD640EPR Guide D'installation page 7

If the dishwasher is to be installed in a corner, ensure that
there is adequate clearance to open the door as shown.
3 Installation Preparation
Installation Preparation
After locating the proper place for your dishwasher, create
Installation Preparation
an opening to allow for water, drain and electrical lines on
the appropriate side.
Cut a hole within the 7 x 2.5" area shown.
1.
7"
(17.8 cm)
If the opening is made through wood, sand it smooth
with coarse sandpaper.
If the opening is made through metal, use the Edge
Protector with Power Cord clips Kit SMZEPCC1UC.
2 ½"
(6.3 cm)
ø 2 ½"
(6.3 cm)
or
Pull the drain hose out of the packaging base as shown.
2.
Set the toe panel aside for later use.
3.
Remove the hose clip at the back of the dishwasher.
4.
It can be used later to hold the drain hose inside your
cabinet.
4 Installation Procedure
Installation Procedure
Follow these instructions to install the dishwasher.
Installation Procedure
4.1 Attach Water Inlet Hose
NOTICE:
Water inlet filter
Do not remove the filter from inside the water inlet valve
▶
when connecting the water supply. It is a debris filter,
not a cap, which must be in place for proper operation.
Avoid cross-threading
Cross-threading will cause leaks.
▶
Installation Preparation en-us
7