Crivit SP-150 Mode D'emploi page 5

5. Visor
• To remove the visor, gently push it down until the visor's attachment openings come out of
the helmet's attachment bars (Fig. H).
• To attach the visor, carefully press the visor's attachment openings into the opening provi-
ded on the helmet until the visor locks into the helmet's attachment bars on both sides.
Caution: The attachment openings on the visor may widen due to
excessive use. In this case, the visor must no longer be used.
6. Ear padding
• To remove the ear padding, carefully pull it down until the ear padding attachment
opening hole comes out of the helmet's attachment bar (Fig. I).
• To attach the ear padding, carefully press the attachment opening of the ear padding into
the opening provided on the helmet until the ear padding locks into the helmet's attach-
ment bar.
Caution: The attachment opening on the ear padding may
widen due to excessive use. In this case, the ear padding must no
longer be used.
7. Setting the ventilation
• Push the adjuster back to open the air slots and increase
• Push the adjuster forward to close the air slots and reduce ventilation (Fig. K).
8. Cleaning and care
• All chemicals, paints and stickers can seriously impair the protective effect of the helmet.
• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.
• The inner pads are removable. Clean the inner padding with lukewarm water and mild
soap and then let it air dry.
9. Disposal
• Please contact your local waste disposal company for the disposal of the helmet.
PO-2024-38_Lidl_BDA_Inside_LB8.indd 7 PO-2024-38_Lidl_BDA_Inside_LB8.indd 7
Urban Bicycle helmet SP-150 / LED-rear light SP-150
7
ventilation (Fig. J).
GB IE
27.10.2023 17:01:22 27.10.2023 17:01:22