Selve commeo Receive Notice De Réglage page 48

EN iveo initial operation/Setting
6.5. Reprogramming if a transmitter is damaged or lost
Only use if a programmed transmitter is no longer available
(damaged or lost)!
In order to program a new transmitter, the receiver has to be put
into reprogramming mode by disconnecting it from the mains
supply. Subsequently press the PROG button of the new
t ransmitter for 3 sec. All the old transmitters have been depro-
grammed.
Fuse
3 s 3 s
6.6. Resetting to the delivery status
To return the receiver to the state at delivery, the receiver must
be brought into service mode by disconnecting it.
Then press the PROG button of an assigned transmitter for
9 seconds.
The receiver will then have no transmitters or limit positions
saved.
Fuse
3 s 3 s
3 s
3 s
New transmitter
➧
3 s
Assigned transmitter
➧
9 s
48