Selve commeo Receive Notice De Réglage page 35

commeo initial operation/Setting
5. commeo initial operation/Setting
commeo initial operation
The commeo initial operation is only possible using commeo
transmitters. To complete the settings in the receiver, the recei-
ver must be selected with a transmitter in SELECT mode. In
SELECT mode, there is only one connection at a time to a
receiver. Only this one can be moved and set.
5.1. Selection of a receiver
By pressing the SELECT button for 3 seconds the transmitter
will be put into the SELECT mode. After the SELECT mode has
been started, the status LED will start to flash quickly and the
transmitter will look for the receiver. The status LED being lit in
green indicates that the receiver has been found and the status
LED will flash slowly in orange. The first receiver completes a
brief confirmation run. If no receivers have been found this will
be indicated by the status LED being lit in red.
Receiver selection with non-programmed transmitter/
initial operation
➧
>1 s
or
Receiver selection with programmed transmitter
1. S elect the transmitter channel on which the recei-
ver is programmed.
2. P ush the SELECT button at the transmitter for
3 seconds. The transmitter is in SELECT mode.
3 s
Note: The receivers found by this method can now be found
using another non-programmed transmitter within 4 minutes.
Press the SELECT button on the additional transmitter for
3 seconds for this purpose. T he transmitter is in SELECT mode.
All settings can now be completed with both transmitters.
1. I nterrupt the voltage supply of
the receivers for > 1 second. The
receivers can be found within the
next 4 minutes.
3 s
2. P ush the SELECT button at the
transmitter for 3 seconds. The
transmitter is in SELECT mode.
35
EN
EN