Selve commeo Receive Notice De Réglage page 41

commeo initial operation/Setting
Configuration using a transmitter without display
The status LED starts flashing green or red slowly. The trans-
mitter shows the first bit. The first bit is displayed by one flash.
Use the UP button to set the first bit to 1 (green status LED) and
the DOWN button to set it to 0 (red status LED). Pushing the
STOP button calls the next bit. The status LED shows the
second bit; the status LED flashes green or red 2 x in sequence.
Every push of the STOP button jumps forward one bit. The bit
can be set as described above. The frequency of flashing cor-
responds to the bit position.
After setting the last bit, pushing the STOP button leaves
the CONFIGURATION mode. The status LED starts flashing
orange. The transmitter is in SELECT mode.
Operation
+
3 s
Status LED
green = 1
1 x
red = 0
green = 1
2 x
red = 0
1 s
green = 1
3 x
1 s red = 0
orange
1 s
41
Setting
= green = 1
= red = 0
= green = 1
= red = 0
= green = 1
= red = 0
EN
EN