Selve commeo Receive Notice De Réglage page 40

EN commeo initial operation/Setting
Note for settings under point 5.2.: The motor/receiver must
be selected for this setting with a transmitter in SELECT mode
(Status LED flashes slowly in orange). After completing the
setting, the motor/receiver is still selected (see point 5.).
5.2.4. Reset the receiver to the factory setting
To reset a receiver to factory settings, push the PROG button
on the transmitter for 9 seconds. All settings are reset to facto-
ry settings. There are no transmitters and end positions saved
in the motor anymore! T he programmed receiver has been can-
celled in the transmitter.
Note: This causes an error message if there are
any more programmed receivers!
I f this receiver in operating mode moves over a trans-
mitter which is still programmed, the transmitter will
no longer receive a response and will acknowledge
9 s
this with an error message.
5.2.5. CONFIGURATION mode (only for authorised qualified
personnel)
To set a receiver to the CONFIGURATION mode, push the
STOP and PROG buttons at the same time for 3 seconds.
+
3 s
Concurrent pushing of the STOP and PROG buttons for
3 seconds permits leaving the CONFIGURATION mode pre-
maturely.
Note: Only for authorised qualified per-
sonnel!
C hanges on the configuration adjustment
can lead to a damage of the construction
since security systems may be switched
off.
40