Publicité
Les langues disponibles
Les langues disponibles
• you use heat-resistant finishes that are easy to clean (such as ceramic tiles) for the wall
surfaces surrounding the hob.
After installing the hob, make sure that
• the power supply cable is not accessible through cupboard doors or drawers
• there is adequate flow of fresh air from outside the cabinetry to the base of the hob
• if the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installed below the base of the hob
• the customer can easily access the isolating switch
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force to the controls protruding from the hob.
Locating the fixing brackets
• The unit should be placed on a stable, smooth surface (use the packaging).
Do not apply force to the controls protruding from the hob.
Cautions
1. Only qualified personnel or technicians may install the induction hotplate. Our
professionals at your service. Please never carry out the operation by yourself.
2. Do not install the hob directly above a dishwasher, fridge, freezer,
washing machine or clothes dryer, as the humidity may damage the hob electronics
3. Install the induction hotplate in such a way as to ensure good heat radiation to enhance
its reliability.
4. The wall and induced heating zone above the table surface must be heat resistant.
5. To avoid any damage, the sandwich layer and adhesive must be heat resistant.
Connecting the hob to the mains power supply
Only a suitably qualified person may connect this hob to the mains power supply
hob to the mains power supply, check that:
1. the domestic wiring system is suitable for the power drawn by the hob.
2. the voltage matches the value given in the rating plate
3. the power supply cable sections can withstand the load specified on the rating plate. When
connecting the hob to the mains power supply, do not use adapters, reducers or branching devices
as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned to ensure that its
temperature will not exceed 75°C at any point.
20
.
Before connecting the
Publicité
