Bertazzoni P603I30NV Manuel D'installation Et D'utilisation page 39

Installation
Choosing installation equipment
Cut out the work surface according to the sizes shown in the drawing.
Leave a space of at least 5 cm around the hole for the purpose of installation and use.
Make sure the work surface is at least 30 mm thick. Please select a heat-resistant work
surface material to avoid extensive deformation due to the heat radiated by the hotplate. As
shown below:
L(mm) W(mm)
590 520
H(mm) D(mm)
60 55
A(mm) B(mm)
560 490
16
X(mm)
50 min.