Publicité
Les langues disponibles
Les langues disponibles
5
Mounting
5 Mounting
DANGER!
The pressure transmitter does not meet the "Equipment with safety function" requirements ac-
cording to the Pressure Equipment Directive 2014/68/EU.
The current relevant regulations must be observed for dangerous media, e.g. oxygen, acetylene,
flammable, and poisonous substances, as well as for cooling systems and pressure tanks etc.
The national and international safety and accident prevention regulations must be observed!
Failure to observe these guidelines may result in bodily injuries and material damage!
The plant operator is responsible for compliance with the legal regulations!
Only suitably qualified persons are permitted to work at this device.
5.1
General information
Prior to mounting
DANGER!
Depressurize the plant prior to mounting the pressure transmitter!
CAUTION!
The pressure transmitter may only be used for media to which the membrane is sufficiently
chemically resistant (corrosion).
Ensure there is an electrically conductive connection between the pressure transmitter and the
process connection (plant).
NOTE!
Select a freely accessible and low-vibration installation location, preferably near the measuring point.
Ensure the admissible ambient temperature is adhered to (take into account possible heat radiation).
The pressure transmitter may be mounted above or below the pressure sensing point.
The rated position of the pressure transmitter is upright. The pressure transmitter may also be mounted
in another position depending on the measuring point conditions.
NOTE!
For the special conditions for use, the examination certificate must be observed,
chapter 8 "Certificates", Page 23.
14
Publicité
