Krüger & Matz KM1995 Manuel De L'utilisateur page 15

Set alarm timer
Note: Make sure that you have set the time correctly.
1. In standby mode, press and hold TIMER button, until
[TIMER SET] scrolls on the display.
2. Use the next and previous buttons to select the sound
source and press the TIMER button.
3. Set the hour of the timer and press the TIMER button. Set
the minutes of the timer and press the TIMER button.
4. Set the timer volume with the next / previous track
buttons and press the TIMER button.
5. The timer has been set and enabled. When the timer is
enabled, the clock icon is shown on the display. To disable
the timer press the TIMER button.
Playing from USB
After connecting the USB device (flash drive, card reader),
the device will play tracks saved on this USB drive. To do
this:
1. Plug the USB device to the USB socket on the back of
the main unit.
2. Press the source button, or the CD/USB button on the
remote to go to the USB playing mode.
3. To start playing, press the play button on the main unit
or on the remote.
EN 4. To stop playing, press the stop button on the main unit
or on the remote.
5. To change tracks, use the next / previous track buttons.
6. To change the album, use the album change buttons.
28
Owner's manual Owner's manual
Charging external devices
When the device is plugged to power, the USB port can be
used to charge external devices. Maximum input voltage is
5 V / 1 A.
Playing CDs
1. Press the SOURCE button on the main unit, or press the
2. Press the disc eject button on the main unit or on the
3. To start playing, press the play button on the main unit
4. To stop playing, press the stop button on the main unit
5. To change tracks, use the next / previous track buttons.
Programming playing
This device comes with a feature of playing just the
selected tracks from the CD.
1. To start programming press the STOP button on the
2. Press the PROGRAM button on the remote- the display
3. To select a track number, press the next / previous
4. To confirm the track and go to select next track, press
5. To start playing programmed tracks, press the play
6. To turn off playing programmed tracks and return to
CD/USB button on the remote. The "DISC" message will
appear on the display.
remote, place the CD on the tray and press the disc
eject button again.
or on the remote.
or on the remote.
remote/main unit.
will show 001 P-01.
buttons. The track number will be shown on the
display.
the PROGRAM button. Keep programming the tracks.
button.
normal playing, press the STOP button twice.
EN
29