Sound Mode; Firmware; Remote Control - Renkforce GM215 Mode D'emploi

c) Sound mode
Rendering of preinstalled device internal chases, controlled via the internal microphone (music control).
• Select the sound mode (display SOUN) using the MENU key.
• Press the ENTER key to switch to the submenu.
• Select the desired sound program (Sd00-Sd16) with the UP, respectively DOWN key.
d) Firmware
• Press the MENU key as often as is necessary until vEr appears in the display.
• Press the ENTER key to display the device's firmware version.
e) Remote control
If a DMX controller is connected , this must be switched off in order to use all functions of the

remote control.

• Remove the any insulating pad in the battery compartment of the remote control. This pad protects the
battery from discharging during transport.
• Hold the remote control in the direction of the IR receiver on the device front side. There should be a
line-of-sight to the sensor.
• The remote control operating range is about 8 meters. Replace the button battery when the range de-
creases considerably, or when the device does not respond any longer to the remote control. See in
addition the point "Replacing the Remote Control Battery".
BLACK OUT
Press this button to turn spotlight device on or off.
Numeric keys
Via numeric keys (0-9) the inputting of the programs can be made directly.
Function of the 0 key in automatic mode: By pressing the 0 key is selected the automatic mode Pr10.
Function of the 0 key in sound mode: By pressing the 0 key is selected the sound mode Sd00.
SOUND
This key activates the SOUND function.
Press the SOUND key. Select the individual SOUND program by pressing the SOUND key (Sd00-Sd16), the
+/- keys (Sd00-Sd16) or the numeric keys (Sd00-Sd09).
29