Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Cabinet Use Requirements
Intended for use in a garage.
Maximum weight limit is 45 lbs (20 kg) for the shelf.
Maximum weight limit is 30 lbs (13 kg) for the drawer.
Maximum weight limit is 300 lbs (136 kg) for the cabinet.
Unpack Cabinet Parts
1. Remove and verify the contents. Contents include an Allen
wrench, a key, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.
Assemble Cabinet
F1
⁵⁄₁₆
F1
" Allen-head bolt (24)
⁵⁄₁₆
F2
" Flange nut (24)
Gather the required tools before starting installation.
Tools Needed:
¹⁄₂" Wrench
³⁄₈" Wrench
¹¹⁄₃₂" Wrench
Tools Supplied:
Allen wrench
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
As you assemble the cabinet, make sure the edges with the
holes are facing up.
If you are assembling the cabinet on the floor, fasten the eight
front corner bolts, two at each corner, after you stand the cabinet
upright.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel (P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
six Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) as shown. Do
not tighten completely.
4. Position side panel (P3) so that the top (P2) is between the edges
of side panel (P3).
ASSEMBLY INSTRUCTIONS
F2
Phillips screwdriver
Pliers
Level
Key
5. Align the holes and attach the top (P2) to the side (P3) using
six Allen-head bolts (F1) and ⁵⁄₁₆" flange nuts (F2) as shown. Do
not tighten completely.
6. Insert cabinet bottom (P4) between the edges of side panels
(P1 and P3).
NOTE: Make sure the edges with the holes are facing up.
7. Align the holes and attach the bottom (P4) to the side panels
(P1 and P3) using six Allen-head bolts (F1) and ⁵⁄₁₆" flange
nuts (F2) for each side as shown. Do not tighten completely.
P1
P2
Attach Lower Back Panel
F3b Phillips-head screw (7 - black)
1. Using seven Phillips-head screws (F3b), attach the lower back
panel (P6) to the bottom (P4) and sides (P1 and P3) as shown.
Tighten screws completely.
2. Using the Allen wrench (provided), completely tighten all the
cabinet bolts and nuts.
P3
P4
P4
P3
P2
F3b
P6
P2
P1
P3
3
Publicité
Table des Matières
