Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Shelf
F3b
F3b Phillips-head screw (4 - black)
IMPORTANT: The shelf may be installed using any of the lower sets
of holes in the cabinet sides.
1. Place the shelf (P9) so that the holes in the ends are aligned with
the desired set of holes in the cabinet sides (P1 and P3).
2. Using two Phillips-head screws (F3b) and two small flange nuts
(F4) per side, fasten the shelf to the cabinet sides (P1 and P3).
Install Doors
F3b Phillips-head screw (6 - black)
IMPORTANT: The door with the lock assembly (P11) should be
installed on the right-hand side of the cabinet.
1. Align three holes in the left-hand door hinge (P10) with the three
holes in the left-hand side.
NOTE: There are two holes in the middle of the door hinge. Align
the top and bottom holes first. Only one of the middle holes will
align.
2. Using three Phillips-head screws (F3b), starting with the center
hole, attach the door (P10) to the side (P1) as shown. Do not
tighten completely.
P10
A. Location for Phillips-head screws
3. Repeat Steps 1 and 2 to attach the right-hand door (P11) to the
side (P3).
4. Align the doors and completely tighten the screws.
6
F4
F4 Small flange nut (4)
F3b
P2
D5
P8
P9
A
P4
Complete the Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on the inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling legs (P7). Turn to
the left to raise or to the right to lower the leveling leg.
4. If the doors are not aligned, loosen all the screws attaching the
door hinge to the cabinet.
5. Adjust door to the desired height, and fully tighten the screws.
ACCESSORIES
To order accessories, call 1-866-342-4089 and ask for the accessory
part number listed below or contact your authorized Gladiator
dealer. In Canada, call 1-800-807-6777.
Caster Kit
Order Part # GACK04KDSX
VersaTop™ Work Surface
Order Part # GAVT18SPSX
®
Publicité
Table des Matières
