Attach Upper Back Panel; Install Door Latch Bar - Gladiator GAGB28KDSG03 Instructions D'assemblage

8. Once the drawer is in place, work from the rear of the cabinet to
completely tighten the six screws attaching the drawer back.
D2
P3
P6
A. Tighten drawer screws

Attach Upper Back Panel

F3b Phillips-head screw (9 - black)
1. Align back panel (P5) with the holes in the top (P2). Using seven
Phillips-head screws (F3b), attach back panel (P5) to the top (P2)
and sides (P1 and P3) as shown. Do not tighten screws
completely.
NOTE: Back panel (P5) will slightly overlap back panel (P6)
2. Using two Phillips-head screws (F3b), attach the upper back
panel (P5) to the lower back panel (P6) as shown.
3. Completely tighten all back panel screws starting with the sides
and continuing with the top, middle, and bottom.
P5
A
P2
P1
F3b
P2
D2
P1
P6

Install Door Latch Bar

F3b
F3b Phillips-head screw (4 - black)
F5 Door catch pin (1)
IMPORTANT: So the doors will close and lock, the latch bar (P8)
must be installed using the indicated pair of holes on each cabinet
side.
1. Align the latch bar with the pair of holes shown.
NOTE: Make sure the slot in the latch bar is facing down.
2. Using two Phillips-head screws (F3b) per side, fasten the latch
bar (P8) to the cabinet sides (P1 and P3).
P1
A
A. Holes for installing latch bar
B. Slot in latch bar
3. Insert the door catch pin (F5) into the hole in the front edge of the
latch bar (P8) and fasten it with the star nut (F6).
D5
A
P1
A. Door catch pin and star nut
F5 F6
F6 Star nut (1)
D5
P8
B
P2
P8
P6
P3
P4
5