Publicité
Les langues disponibles
Les langues disponibles
System Specifications*
Altec Lansing's superior sound comes from our patented Dynamic EQ technology,
which utilizes custom-built, high-fidelity drivers, state-of-the-art equalization circuitry,
and a harmonious mix of the following specifications:
Sound Pressure Level (SPL):
Total Continuous Power:
• Front Speakers:
• Subwoofer:
System Response:
Signal to Noise Ratio
@ 1 kHz input:
Drivers (per satellite):
Subwoofer:
*Power rating conforms to FTC Amplifier Rule #16 C.F.R. Part 432.
Troubleshooting
Symptom
Possible Problem
No LEDs are lit.
Power isn't turned on.
AC power cord isn't connected to the wall outlet.
Surge protector (if used) isn't powered on.
Wall outlet not functioning.
No sound from
Power isn't turned on.
one or more
speakers.
Volume is set too low.
3.5mm stereo cable isn't connected to audio source.
3.5mm stereo cable is connected to wrong output on
audio source.
Problem with audio source device.
Crackling sound
Bad connection.
from speakers.
Volume level in computer operating system is set too
high.
A problem with your audio source device.
All manuals and user guides at all-guides.com
99 dB
30 Watts RMS
6 Watts/channel @ 4 ohms
@ 10% THD @ 150 – 18000 Hz
2 Channels Loaded
18 Watts @ 8 ohms @ 10% THD
@ 30 – 150 Hz
Single Channel Loaded
40 Hz – 20 kHz (-10 dB)
> 75 dB
Two 2" full-range driver
One 5.25" woofer
POWER REQUIREMENTS
USA, Canada and applicable
Latin American countries:
Europe, United Kingdom,
applicable Asian countries,
Argentina, Chile and Uruguay:
ETL/cETL/CE/NOM Approved
Solution
Turn the VOLUME knob on the control pod until you hear a click sound.
An LED will light on the control pod when the power is ON.
Check to see if the "Power On" LED is illuminated on the control pod. If not,
connect AC power.
If the AC power cord is plugged into a surge protector, make sure the surge
protector is switched on.
Plug another device into the wall outlet (same jack) to verify the wall outlet
is working.
Verify the AC power cord is plugged into the wall outlet.
Turn the VOLUME knob on the control pod until you hear a click sound.
An LED will light on the control pod when the power is ON.
Turn the VOLUME knob clockwise to raise the volume.
Check volume level on the computer sound card or alternate audio source
device, and set at mid-level.
Check plug connections on the audio source. Make sure the signal cables are
inserted firmly into the correct jacks.
Make sure the 3.5mm stereo cable is connected and fully inserted into the
"line-out," "audio-out," or the headphone jack of the audio source.
Test the speakers on another audio device. Remove the 3.5mm stereo cable
from the audio source device and connect it to the "line-out," "audio-out,"
or the headphone jack of another audio source.
Check all cables. Make sure they are connected to the "line-out" or "audio-out"
jack on your sound card or other audio source — NOT "speaker-out."
Check the computer operating system volume level and decrease it if necessary.
Unplug the stereo cable from the audio source. Then plug it into the
headphone jack of an alternate audio source (e.g., Walkman, Discman or
FM radio).
3
120 V AC @ 60 Hz
230 V AC @ 50 Hz
Publicité
