Parkside PSHL 2 D1 Consignes D'utilisation Et De Sécurité page 7

Headband
5
Rear control dial headband
6
Lateral control dial headband
7
UV filter
8
Darkening control
9
Test button
10
Delay setting
11
Sensitivity setting
12
z Technical specifications
Filter cassette size:
Field of vision:
Light condition:
Dark condition:
Cycle times
Light to dark:
Dark to light:
NOTE: Changes to technical and visual aspects of the product may be made as part of future de-
velopments without notice. Accordingly, no warranty is offered for the physical dimensions, information
and specifications in these operating instructions. The operating instructions cannot therefore be used as
the basis for asserting a legal claim.
Safety instructions
z
Please read the operating instructions with care and observe the
notes described. Familiarise yourself with the device, its proper use
and the safety notes based on these operating instructions. The rating
plate contains all technical data of this welding helmet; please learn
about the technical features of this product.
Prior to each use, check that it is working properly by pressing the
„
"Test" button.
The product is not suitable for laser welding.
„
The product is only approved for use within a temperature range of
„
110x90x15 mm Switching on/off Filter:
9.2x4.2 cm Switching on/off LED:
DIN 4 Energy supply:
DIN 5 – DIN 9 / UV/IR protection:
DIN 9 – DIN 13
Operating temperature:
Storage temperature:
0.23 – 0.72 ms
Welding processes:
0.1 – 2 s
Maximum service life:
Low battery display
13
LED light switch
14
Battery compartment
15
Arc sensor
17
Slide
18
LED light
19
Darkening switch
20
Fully automatic
manual
Solar cell
DIN 16
-5 °C to +55 °C
-20 °C to +70 °C
MMA, MIG, MAG, TIG,
plasma cutting and
plasma welding
approx. 5 years
GB/IE/NI/CY/MT
7