Pando E-237 Manuel D'utilisation Et D'installation page 47

AN- CONTROL IN MAINTENANCE MODE MANUAL
1.
The hood must be completely off, with motor and lights
2.
To access Maintenance Mode, once the hood is off (motor and lights OFF):
a) Press the ON/OFF button on the control for 5 seconds, it will begin to emit an intermittent beep and the multi-
color pilot light will shine red, at the same time the filters and panels module will begin to move down about 100 cm.
While descending, it is possible to stop it before it reaches the end by simply pressing the ON/OFF button again, if
you want it to continue descending, press the ON/OFF button for 5 seconds.
b) To raise the filter module, press the Last Time button for 5 seconds, it will begin to emit an intermittent beep and
the multi-color pilot light will shine red while at the same time, the filter module and panels will begin to move up to
the hood in the ceiling.
While moving, it is possible to stop it before reaching the end by simply pressing the Last Time button, if you want it
to continue rising, press the Last Time button again for 5 seconds.
While in maintenance mode, the motor cannot be turned on, it will be locked, the lights, however, can be turned on.
≈ 5 " (Up)
3.
In maintenance mode, while the hood body module containing the panels and filters moves up and down, acoustic
and visual signals are emitted,
the led control pilot light for the motor, which will flash red.
4.
There is an "anti-entrapment" protection system that acts in the raising process, in case of a panel
obstruction, it will automatically stop.
APPROXIMATE HOOD HEIGHTS IN MAINTENANCE MODE
HOOD / MOTOR
FRAME / FILTERS
PANEL OPEN
WORKTOP
the acoustic is a continuous 2-second beep with intervals of 1
Beep
Beep...
ACCORDING TO FLOOR TO CEILING HEIGHT: 230/ 240/ 250cm
230
140
100
40
10
90
130
OFF.
240
150
50
20
30
140
47
≈ 5 " (
Down)
second, the visual is
250
160
60
150