EIBENSTOCK ETR 400.2 P Notice Originale page 26

Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an electric
specialist. Due to its design, the machine needs a minimum of care and
maintenance. However, the following points always have to be observed:
 Always keep the power tool and the ventilation slots clean.
 During work, please pay attention that no particles get inside the
machine.
 In case of failure, a repair has to be carried out by an authorised service
workshop.
Auto-stop brushes
In order to protect the motor, this power tool is equipped with auto-stop brushes.
When the carbon brushes are worn out, the machine switches itself off. In this
case both brushes must be replaced at the same time with original brushes by
an electrical specialist.
Environmental Protection
Raw material recycling instead of waste disposal
To avoid damages on transportation, the power tool has to be delivered in a
sturdy packing. Packaging as well as unit and accessories are made of
recyclable materials and can be disposed accordingly.
The tool's plastic components are marked according to their material, which
makes it possible to remove environmental friendly and differentiated because
of available collection facilities.
In addition there is a service indicator (I) on the operating
handle which indicates in advance that the machine is
about to shut down due to worn carbon brushes. After the
indicator lights up, you can use the tool for approximately 1
day. Then the carbon brushes should be replaced.
Only for EU countries
Do not dispose of electric tools together with household
waste material! In observance of the European Directive
2012/19/EU on waste electrical and electronic equipment
and its implementation in accordance with national law,
electric tools that have reached the end of their life must be
collected separately and returned to an environmentally
compatible recycling facility.
26