EIBENSTOCK ETR 400.2 P Notice Originale page 24

Screw the flange (C) onto the spindle and tighten it with the help of the
assembly tool (D) whilst actuating the spindle lock at the same time.
When using diamond cutting discs, pay attention that the direction-of-rotation
arrow on the diamond cutting disc and the direction of rotation of the machine
(see direction-of-rotation arrow on the machine head) agree.
In order to check whether the spindle stop is released before you switch
on the tool, turn the spindle slightly. Check grinding tools before using.
The grinding tool must be mounted properly and be able to move freely.
Carry out a test run for at least one minute with no load. Do not use
damaged, out-of-centre or vibrating grinding tools. Damaged grinding tools
can burst and cause injuries.
Instructions for Use

Exercise caution when cutting slots in structural walls; see
Section "Information on Structures".

Clamp the workpiece if it does not remain stationary due to its own
weight.

Do not strain the machine so heavily that it comes to a standstill.

After heavily straining the power tool, continue to run it at no-load
for several minutes to cool down the accessory.

Do not touch grinding and cutting discs before they have cooled
down. The discs can become very hot while working.
Protect the cutting disc against impact, shock and grease. Do not subject the
cutting disc to lateral pressure.
To supply the machine with water please proceed as follows:
 Connect the tool to the water supply system or a water pressure vessel
using the GARDENA connector (H).
 Always make sure that the machine only runs with enough clear water as
the seals get damaged when the machine is running dry. The water feed
can be regulated via a miniature ball valve.
 Attention! The maximum water pressure should not exceed 3 bar!
Make sure that the segments are well cooled. If the drilling water is clear,

the segments are well cooled.
 In case of frost warning, drain the water system.
24