Publicité
Les langues disponibles
Les langues disponibles
Ein-/ Ausschalten
1
2
Protective cover
Attention!
Before any work on the tool, disconnect the plug from the mains!
Operate the power tool only with installed protective cover and auxiliary handle.
The position of the protective cover on the machine can be adjusted according
on the application.
To do this, loosen the tension lever (E) on the clamping flange. Turn the
protective cover to the desired position and retighten the tension lever (E) firmly.
Changing the Cutting Discs
Attention!
The Cutting discs, spacer discs and the flange nut might heat up
enormously during operation. You could burn your hands or get cut or
ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
Attention!
Before any work on the tool, disconnect the plug from the mains!
Pay attention to the dimensions of the grinding tools. The mounting hole
diameter must fit the mounting flange without play. Do not use reducers
or adapters.
Changing the cutting wheel:
For clamping and loosening the cutting tools, lock the grinder spindle with the
spindle lock button (B). Actuate the spindle lock button only when the grinder
spindle is at a standstill. Otherwise, the machine may become damaged. With
this button depressed rotate the wheel until it has profoundly gone deeper.
The flange (C) can be detached using the supplied wrench (D).
Unscrew the flange completely from the spindle.
Now detach the cutting disc from the machine mount a new disc.
The diamond cutting disc must always be mounted between the two
clamping discs!
Switching-on:
Slide the lock (1) in the direction of the
arrow and press the trigger switch (2).
Switching-off:
Release the on/off switch (2)
23
Publicité
