Publicité
Les langues disponibles
Les langues disponibles
3a
INSTALL 50/50 POP-UP DRAIN (SKU 7075002)
• Drop FLANGE (1) into LAVATORY DRAIN
(2). From below assemble RUBBER
GASKET (3), METAL WASHER (4) and
LOCK NUT (5). Do not tighten.
3b
INSTALL 50/50 POP-UP DRAIN (SKU 7075002)
• Place SEAL (1) with small end facing up
into TAILPIECE (2) and tighten against
DRAIN BODY (4). PIVOT ROD (3) opening
in TAILPIECE (2) should face the rear of
the lavatory. Tighten LOCK NUT (5) with
channel locks. Do not over tighten.
3c
INSTALL 50/50 POP-UP DRAIN (SKU 7075002)
• Assemble PIVOT ROD (1), PIVOT NUT (2), CLIP (3)
and SEAL (4) as shown. Hand tighten PIVOT NUT
(2) Drop STOPPER (5) into drain.
(For vandal proof drain rotate stopper so PIVOT
ROD (1) goes through EYE (6) of STOPPER (5).
Make connection to "P" TRAP.
• Remove one end of CLIP (3) from PIVOT ROD (1)
by squeezing ends together while sliding.
• Insert PIVOT ROD (1) into second or third hole in
EXTENSION (7) and reassemble CLIP (3).
(EXTENSION (7) may need to be bent.)
• Adjust STOPPER (5) height by repositioning
EXTENSION (7) and tightening THUMBSCREW (8).
3
4
5
1
3
2
5
8
7
1
3
2
4
1
2
4
5
6
Publicité
