Publicité
Les langues disponibles
Les langues disponibles
2
INSTALL POP-UP METAL DRAIN (SKU 7075000)
• Push TAIL PIECE (11) down into TRAP (C) (threaded end up).
• Thread LOCKNUT (5), WASHER (4) and GASKET (3) (Bevel side up) onto DRAIN BODY (10).
• Apply a bead of PUTTY (D) to underside of FLANGE (2).
• Feed DRAIN BODY (10) up through SINK (A) and thread the FLANGE (2) fully onto DRAIN BODY (10).
• Tighten LOCKNUT (5) firmly, keeping the pivot rod hole pointed towards the back of the sink.
• Assemble PIVOT ROD (9) as shown in Figure-2a. Notice the position of the CONCAVE WASHER (G).
• Insert PIVOT ROD (9) into DRAIN BODY (10) and tighten PIVOT NUT (F).
• Pull TAIL PIECE (11) up and thread tightly into DRAIN BODY (10).
• Position EXTENSION ROD (7) onto POP-UP ROD (E) and tighten THUMBSCREW (6).
• Remove one end of CLIP (8) from PIVOT ROD (9) by squeezing ends together while sliding.
• Insert PIVOT ROD (9) into second or third hole in EXTENSION ROD (7) and reassemble CLIP (8).
• Drop STOPPER (1) into DRAIN BODY (10).
• Adjust stopper height by repositioning EXTENSION ROD (7) and tightening THUMBSCREW (6).
3
CHECK OPERATION OF POP-UP METAL DRAIN (SKU 7075000)
• Operate LIFT KNOB (1) to verify that
STOPPER (2) opens and closes.
1
2
D
A
E
3
6
4
7
5
10
F
C
11
1-1/4"
2a
G
F
8
9
1
2
Publicité
