cecotec THERMOSENSE 400 VISIONLIGHT Manuel D'instructions page 5

- Avoid touching the hot surfaces of the kettle and let it cool
down for a few minutes after use. Grab it by the handle. The
kettle surfaces are likely to be hot during use.
- To prevent possible injury caused by steam, do not face the
spout when operating the kettle.
- Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is earthed.
- Do not immerse the cable, plug, or any other
non-removable part of the appliance in water or any other
liquid. Do not expose the electrical connections to water.
Make sure your hands are dry before handling the plug or
switching on the device.
- Never immerse the appliance in water. Do not touch the
water!
- Check the power cable regularly for visible damage. If the
cable is damaged, it must be repaired by the official Cecotec
Technical Support Service to avoid any type of danger.
- Do not carry or pull the appliance from the power cable. Do
not use the power cable as handle. Do not push the cable
against corners or sharp edges. Do not crush the power
cable with the full weight of the appliance. Keep the cable
away from hot surfaces.
- Do not operate the appliance if its cable, plug, or body show
visible damage, do not operate properly, or have been
dropped.
- Do not use the appliance in confined spaces with explosive
or flammable vapours.
- Do not leave the appliance unattended while in use.
- Unplug it from the power supply when you finish using it
and before leaving the room.
- Do not try to repair the appliance by yourself. Contact the
official Cecotec Technical Support Service.
8
THERMOSENSE 400 VISIONLIGHT
- Always turn off and unplug the appliance when not in use,
before moving it to a new location, and before assembling
or disassembling it. To avoid tripping hazards, wind the
cable safely.
- To ensure the correct operation of the appliance, cleaning
and maintenance tasks must be carried out according to
this instruction manual. Always turn off and unplug the
appliance before cleaning.
- Boiling water may overflow from the kettle.
- Use the appliance only for its intended purpose.
- Fill up the kettle with cold water only.
- The water level must be between the MAX. and MIN. marks.
- Always ensure that the cover is tightly closed.
- The kettle body must match with the kettle base.
- Remove and refit the cover carefully when hot.
- Take extreme precaution when moving the kettle
containing hot water. Never lift the kettle by its cover.
Always use the handle.
- Never switch on your kettle when empty.
- Do not use the base unit for other purposes.
- To avoid scalding, do not open the cover during the boiling
process or immediately after.
9
THERMOSENSE 400 VISIONLIGHT