Télécharger Imprimer la page

cecotec THERMOSENSE 400 VISIONLIGHT Manuel D'instructions page 24

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
ENGLISH
-
If it is between 70 ºC and 79 ºC , it shall be purple.
-
If it is between 80 ºC and 89 ºC , it shall be yellow.
-
If it is between 90 ºC and 100 ºC , it shall be red.
4. CLEANING AND MAINTENANCE
-
Before cleaning the kettle, unplug it and allow it to cool down.
-
Clean the outside of the appliance with a slightly damp sponge or cloth.
Never immerse the appliance in water or other liquids.
-
-
Do not use abrasive cleaners, metal brushes or any other object that may scratch the
surface.
Storage
-
Always disconnect the plug from the mains supply before cleaning the appliance.
-
If the kettle is hot, wait until it completely cools down to clean it.
-
Do not immerse the appliance, its power cable, plug, or base in water.
Do not use steam to clean the kettle.
-
-
The interior and exterior can be cleaned with a slightly dampened cloth. Do not use
powder detergent or abrasive or corrosive cleaning agents, as these could damage the
appliance's surface. Rinse the kettle interior and dry it thoroughly with a soft cloth.
Before storing the appliance, check it is completely dry and store it in a fresh and dry
-
place.
-
If you notice mineral deposits such as limescale, we recommend following the steps
below:
1.
Pour water and a descaler for kitchen appliances in the ratio specified by the
manufacturer.
2.
Let it stand for one hour with the appliance switched off.
3.
Discard the descaler and rinse the kettle with clean water several times until
washing off all descaler residue.
4.
Fill up the kettle and boil some water, then discard it.
5.
If you notice traces of descaler, repeat from step 3.
Warning
Never use ammonia, chlorine, or other appliances to clean or descale the kettle. These could
damage the appliance. Follow only the previous steps.
46
THERMOSENSE 400 VISIONLIGHT
POWER RETRO 1200MAX / POWER RETRO 1200MAX CREAM&CRUSH
5. TROUBLESHOOTING
Problem
Solutions
The kettle does not switch on
Check that it is correctly connected to the mains.
Make sure that the plug works.
Make sure the lever was pressed down.
The kettle does not boil water
Make sure that the water is between the minimum and
maximum level.
Check that it is correctly connected to the mains.
Check that the water is not already hot.
The kettle does not switch off
Check that the cover is correctly fitted.
automatically
6. TECHNICAL SPECIFICATIONS
Product reference: 01449
Product: Thermosense 400 VisionLight electric kettle
Power: 1850-2200 W
Voltage: 220-240 V
Frequency: 50/60 Hz
Maximum capacity: 1.7 l
Technical specifications may change without prior notification to improve product quality.
Made in China | Designed in Spain
7. DISPOSAL OF OLD ELECTRICAL AND ELECTRONIC APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or batteries must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
dispose of the cells/batteries/accumulators and take them to a collection
point designated by the local authorities. 
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
Compliance with the above guidelines will help protecting the environment.
POWER RETRO 1200MAX / POWER RETRO 1200MAX CREAM&CRUSH
ENGLISH
47
THERMOSENSE 400 VISIONLIGHT

Publicité

loading