Bosch GWS 27-230 Professional Notice Originale page 9

a power failure or when the mains plug is pulled. This
prevents uncontrolled restarting.
Secure the workpiece. A workpiece clamped with
u
clamping devices or in a vice is held more secure than by
hand.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended use
The power tool is intended for cutting, roughing and brush-
ing metal and stone materials without the use of water.
A separate protective guard for cutting must be used when
cutting with bonded abrasives.
Sufficient dust extraction must be provided when cutting
stone.
With approved abrasive tools, the power tool can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
Technical Data
Angle grinder
Article number
Rated power input
Rated speed
Max. grinding disc diameter
Grinding spindle thread
Max. thread length of grinding spindle
Restart protection
Soft start
Weight according to EPTA-Procedure 01:2014
– with low-vibration auxiliary handle
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-
specific models.
Only for power tools without starting current limitation: Switching these on causes the voltage to drop briefly. Other tools may
be adversely affected by these if the conditions in the electricity supply are unfavourable. Malfunctions are not to be expected
for system impedances below 0.087 ohm.
Values can vary depending on the product, scope of application and environmental conditions. To find out more, visit
www.bosch-professional.com/wac.
Bosch Power Tools
(1) Spindle lock button
(2) On/off switch
(3) Auxiliary handle (insulated gripping surface)
(4) Grinding spindle
(5) Protective guard for grinding
(6) Locking screw for protective guard
(7) Mounting flange with O‑ring
a)
(8) Grinding disc
(9) Clamping nut
(10) Two-pin spanner for clamping nut
(11) Quick-clamping nut
(12) Carbide grinding head
(13) Protective guard for cutting
a)
(14) Cutting disc
a)
(15) Hand guard
a)
(16) Spacer discs
a)
(17) Rubber sanding pad
a)
(18) Abrasive disc
a)
(19) Round nut
a)
(20) Cup brush
(21) Extraction guard for cutting with cutting guides
a)
(22) Diamond cutting disc
(23) Handle (insulated gripping surface)
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
GWS 27-230 GWS 27-180 J
3 601 HC5 0.. 3 601 HC4 3..
W 2700
–1
min 6500
mm 230
M 14
mm 25
–
–
kg 6.0
/ II
English | 9
a)
a)
a)
a)
a)
GWS 27-230 J
3 601 HC5 3..
2700 2700
8500 6500
180 230
M 14 M 14
25 25
● ●
● ●
5.8 6.0
/ II / II
1 609 92A 8TR | (10.01.2024)