Matrix TF50 Mode D'emploi page 73

ASSEMBLY
SERIAL NUMBER LOCATION
Before proceeding, find your equipment's serial number located on a barcode
sticker and enter it in the space provided below.
SERIAL NUMBER
MODEL NAME
TF30 T50 MATRIX TREADMILL
F F
TF50 T70
F F
* Use the information above when calling for service.
WARNING!
There are several areas during the assembly process that special attention must be paid. It is very important
to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly
instructions are not followed correctly, the equipment could have parts that are not tightened and will seem
loose and may cause irritating noises. To prevent damage to the equipment, the assembly instructions must
be reviewed and corrective actions should be taken.
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on
your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side.
Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled
and in the upright folded position, with the lock latch secure. Unpack and assemble the unit where it will be
used. The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled.
Never grab hold of any portion of the incline frame and attempt to lift or move the treadmill.
WARNING!
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until fully assembled. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly and usage. Please do not wipe this off. If you have
difficulty, a light application of lithium grease is recommended.
73