Publicité
Les langues disponibles
Les langues disponibles
that point in order to protect it from overheating. Then let the device cool down for at least 15 minutes.
We recommend fi rst fi lling a large-volume item with air, in order to then generate the required pressure
with the device.
Checking the air pressure with the portable compressor
PLEASE NOTE: The digital pressure gauge with pressure display
is not trade-approved.
Connect the infl atable item to the compressed air hose with threaded connection
„
compressor
, whose pressure you want to check. To do so, please proceed as described in the
1
section "Connecting the compressed air hose with a valve adapter" or "Connecting the compressed
air hose without a valve adapter".
Switch the portable compressor
„
Use the On/Off switch
„
following units: pounds per square inch ("PSI"), Bar ("Bar") and kilogrammes per square centimetre
("kg/cm²") (see Fig. A).
The digital pressure gauge with pressure display
„
item in the preset unit.
Disconnect the infl atable item from the compressed air hose with threaded connection
„
portable compressor
compressed air hose".
PLEASE NOTE: When disconnecting the compressed air hose with threaded connection
air can escape from the valve of the infl atable item. Ensure that you remove the compressed air hose
with threaded connection
Safety fuse
If the device becomes overloaded or malfunctions, the safety fuse triggers to protect the device.
Never use a fuse with a higher release current strength.
There is a risk of fi re!
ATTENTION: To protect people and property, an overheat protection circuit has been installed for
the rechargeable battery pack in the portable compressor
rechargeable battery pack installed in the device and automatically switches off the portable compressor
if the battery temperature is too high. If this happens, allow the device to cool down prior to using it
1
again.
Attention: The compressor function must not be used while the portable compressor
There is a risk of overheating.
z Switch on lighting
Light mode
To switch on the LED light
„
Press the LED button
„
Flash mode
To switch on the LED light
„
permanently lit.
Briefl y press the LED button
„
Briefl y press the LED button
„
There will be 3 short fl ashes, 3 long fl ashes and another 3 short fl ashes.
Briefl y press the LED button
„
14
GB/IE/NI
on using the On/Off switch
1
to select the desired unit of pressure. There is a choice between the
3
. To do so, please proceed as described in the section "Removing the
1
as quickly as possible.
11
press the LED button
9
three times to turn the LED lights
6
press the LED button
9
once again and the LED light
6
once again and the LED light
6
once again to switch off the LED light
6
of the portable compressor
5
.
3
shows the pressure of the connected infl atable
5
. This prevents an overheating of the
1
once briefl y.
6
off again.
9
once briefl y. The LED light
6
will switch to fl ashing mode.
9
will switch to SOS mode.
9
.
9
1
of the portable
11
of the
11
,
11
is being charged.
1
will then be
9
Publicité
