Publicité
Les langues disponibles
Les langues disponibles
z Using the device
PLEASE NOTE: After being switched on, the display switches off after approx. 30 seconds, if the
compressor is not switched on. Alternatively, the portable compressor
the On/Off switch
for at least 3 seconds.
3
z Checking the capacity of the portable compressor
Switch the portable compressor
„
The number of illuminated bars in the battery symbol on the digital pressure gauge with pressure
„
display
indicates the charge level of the rechargeable battery pack of the portable compressor
5
If the device is fully charged, all four bars will be lit.
„
z Charging the portable compressor
The portable compressor
„
USB adapter
) or an appropriate USB AC adapter (operating peak output voltage U
17
To do this connect the USB cable
„
USB cable
with the 12 V cigarette lighter USB adapter
18
or an appropriate USB plug socket.
PLEASE NOTE: USB AC adapter not included in the scope of delivery.
ATTENTION: Only use the 12 V cigarette lighter USB adapter
the device.
PLEASE NOTE: An undervoltage protection circuit is installed in the portable compressor
protect the device from damage. This prevents a deep discharge of the portable compressor
automatically switches the device off once the rechargeable battery pack is fully discharged. In this case,
the device can no longer be switched on or used. Please re-charge the portable compressor
as described.
z Using the portable compressor
Take off the cover cap for the accessory compartment
„
threaded connection
compressed air hose connection
Do not operate the device in a dusty environment. This is a fire risk and the device could be damaged.
„
PLEASE NOTE: You can either use the compressed air hose with threaded connection
or use it together with the valve adapters
Connecting the compressed air hose without a valve adapter
Screw the free end of the compressed air hose with threaded connection
„
connection valve of the inflatable item.
Connecting the compressed air hose with a valve adapter
The valve adapters
„
(see Fig. C).
First screw the required valve adapter
„
threaded connection
Connect the valve adapters
„
valve cap on inflatable item first if necessary).
12
GB/IE/NI
on by pressing the On/Off switch
1
can be charged with an appropriate USB A plug (e.g. 12 V cigarette lighter
1
to the USB C charging port
18
. Screw the compressed air hose with threaded connection
11
of the portable compressor
8
,
12
13
,
and
are located under the cover cap for the accessory compartment
12
13
14
,
12
.
11
,
or
into the connecting valve on the inflatable item (remove
12
13
14
, an appropriate USB power connection
17
and USB cable
17
and remove the compressed air hose with
15
1
and
supplied as part of the delivery.
14
or
to the free end of the compressed air hose with
13
14
can be switched off by pressing
1
.
3
out, max
of the device. Then connect the
16
as supplied with
18
onto the
11
(see Fig. B or C).
directly on to the
11
.
1
5 V
).
to
1
and
1
,
1
directly
11
15
Publicité
