Publicité
Les langues disponibles
Les langues disponibles
Removing the compressed air hose
Connecting without the valve adapters
„
threaded connection
Connecting with the valve adapters
„
valve of the inflatable item. Unscrew the valve adapters
with threaded connection
PLEASE NOTE: When disconnecting the compressed air hose with threaded connection
can escape from the valve of the inflatable item. Ensure that you remove the compressed air hose with
threaded connection
11
Presetting the air pressure
Switch the portable compressor
„
Connect the compressed air hose with threaded connection
„
inflatable item which you want to inflate. To do so, please proceed as described in the previous section.
Pressing the On/Off switch
„
choice between the following units: pounds per square inch ("PSI"), Bar ("Bar") and kilogrammes
per square centimetre ("kg/cm²") (see Fig. A).
Use the "+" button
„
you can keep the respective button pressed down for longer. Pressure settings between 0.2 bar and
4.1 bar are possible in 0.05 bar steps (see Fig. A).
PLEASE NOTE: If a button is not pressed for 5 seconds, the display will display the ACTUAL value
of the pressure. The pressure which has been set remains stored.
Switch the integrated compressor unit on by pressing the On/Off switch for the compressor
„
The compressor will start and pump up the inflatable item.
„
You can switch off the compressor at any time by pressing the On/Off switch for the compressor
„
once more.
Otherwise, the compressor will switch off automatically once the inflatable item has reached the preset
„
pressure.
Disconnect the inflatable item from the compressed air hose with threaded connection
„
in the previous section.
At the end of the job, unscrew the compressed air hose with threaded connection
„
compressed air hose connection
ATTENTION: During operation, the compressed air hose connection
will get hot. Make sure that you do not come into contact with it during operation to avoid suffering
1
burns. At the end of the job, wait for at least 10 minutes before you unscrew the compressed air hose
with threaded connection
PLEASE NOTE: After being switched on, the display switches off after approx. 30 seconds, if the
compressor is not switched on.
PLEASE NOTE: The digital pressure gauge with pressure display
not trade-approved. After pumping up inflatable items where the wrong pressure could be dangerous
(e.g. bicycle tyres), always check the pressure at a service point with a trade-approved device.
Check the pressure of the inflatable item there.
Tips for use
The device is not intended for continuous operation. The device was designed to create air pressure –
not an air flow. Please do not use the device for more than 5 minutes at a time, to avoid overheating
and damage to the device. After 5 minutes continuous operation the "OH" display flashes on the digital
pressure gauge with pressure display
,
12
off the valve of the inflatable item.
11
,
12
13
(if necessary, reattach the valve cap on to the inflatable item).
11
as quickly as possible.
on using the On/Off switch
1
again will allow you to select the desired unit of pressure. There is a
3
and the "-" button
4
2
of the portable compressor
8
back off the device.
11
. This indicates imminent overheating. Switch the device off at
5
or
: Unscrew the compressed connection hose with
13
14
or
: First undo the valve adapter from the connecting
14
,
or
12
13
3
of the portable compressor
11
to select the desired pressure. To speed up the selection,
1
5
off the compressed air hose
14
.
11
back off the
11
.
of the portable compressor
8
of the portable compressor
GB/IE/NI
, air
11
to the
1
once.
7
7
as described
is
1
13
Publicité
