Mark PinTherm Mistral Livret Technique page 7

4.4 Installation water temperature sensor (06 29 094)
In case of a water-supplied system, place an external sensor at the supply pipe in the area of the
MDA(+) water-supplied air heater. Refer to the chart below for the correct wire diameter and
length.
Diameter Length
0.8mm 2 80 meter
2
1.0mm 100 meter
2
1.5mm 150 meter
Based on the determined actual water temperature, the 0-10V signal will be available. This to
prevent cold air blowing (heating mode) / warm air blowing (cooling mode).
5.0 Operating manual
5.1 Explanation of the push-buttons and LEDs
F
D
B
C
A - Illuminated display (see also 5.2)
B - LED, lit when the fan is switched on
C - LED, lit when there is a fault signal
D - Push-button for activating heating/cooling
E - Continuous fan (only when applying water-supplied units)
F - Push-button for activating the user menu or to display the next value.
G - Push-button for confirming a selection/change or for displaying the next menu item.
H - Push-button for exiting the setting or menu without executing a change.
I - Push-button + – to change a setting.
J - Push-button for switching the overtime timer on and off.
K - LED, lit when there is heat demand in the heating mode.
L - LED, lit when there is cooling demand in the cooling mode.
M - LED, lit when the overtime timer function is active.
In this case, we advise the use of a shielded cable.
A
PinTherm Mistral
0629110
MON 08:01 18ºC
DAY X:060
E
H J
G
I
K
L
M
7
EN