Mark PinTherm Mistral Livret Technique page 15

5.21 IP settings
select
DHCP - automatic assignment IP address
Static - set fixed IP address
SUBnet Mask
The IP adress can be modified via Ethernet.
5.22 Control PinTherm Mistral via Ethernet
After setting the IP address, it is possible to remotely control and change the PinTherm Mistral via
the web browser on your mobile phone, tablet or laptop / PC. To do this, enter your set IP address
in the address bar of the browser. Then log in with the following information:
Username: pintherm
Password: 1000
Setting or changing the parameters is possible via the web browser. See [6] for the screens.
5.23 Switch overtime timer on/off
This function provides the option of manually switching to the daytime temperature outside the set
switching times for a period of 1, 2 or 3 hours.
The yellow LED with the symbol
of the display shows the time in minutes that still remains before the function is deactivated and the
PinTherm Mistral returns to night temperature control. The function can also be switched off pre-
maturely by pressing the push-button again until the yellow LED extinguishes and the number of re-
maining minutes disappears from the display. See the illustration below.
MON 17:01
NIGHT
MON 17:01
DAY
IP SETTINGS
IP ADDRESS
192.168.001.100
changes the
flashing digit
to go one digit up
is lit when this function is active. In addition, the bottom right
18°C
18°C
X:120
IP MODE
STATIQ
OK
change setting
SUBNET MASK
255.255.255.000
changes the
flashing digit
to go one digit up
MON 17:01 18°C
DAY X:060
MON 17:01 18°C
DAY X:180
OK
OK
back to the
menu
15
EN