Mark PinTherm Mistral Livret Technique page 12

5.11 Control settings heating
CONTROL SETTINGS
HEATING
0-10V MIN(0-5V)
changes the
flashing digit
to go up one digit
* This function determines when the 0-10VDC signal is modulated back in conditions of heat demand.
When set to 1.0, the PinTherm Mistral will start to modulate the 0-10V signal at 1K below the target
temperature. The range can be set between 0.5 - 3.0 and is set to 1.0 as standard.
** When there is no heating/cooling demand, the PinTherm Mistral sends out a signal of 0VDC.
5.12 Water temperature
WATER
TEMPERATURE
SETPOINT COOLING
* actual water temperature
12
**
3.0 V
15ºC
changes the
flashing digit
to go up one digit
0-10V RANGE(1-3)
1.0 K
OK
changes the
flashing digit
to go up one digit
0-10V MAX(5-10V)
10.0 V
OK
changes the
flashing digit
to go up one digit
WATER TEMP.
OK
SETPOINT HEATING
OK
*
OK
OK
back to the
menu
*
35.1ºC
30ºC
changes the
flashing digit
to go up one digit
OK
OK
back to the
menu